taper
07-05-2006, 06:43 AM
I've been trying to record VOIP calls with Cain&Abel, but without success.
The calls appear in the VOIP section of the sniffer, but once the call is
completed, all I get is "Codec not supported" and the wav file is not saved. However, if I make a call and there is nobody answering, and then put the phone off hook, it has indeed recorded and saved a single "beep" (someone like 2 seconds), and the status field is left blank instead of displaying
"Codec not supported".
The codec reported is G72*, 8khz, Mono and according to the Cain&Abel manual this codec should actually be supported. So, why doesn't it work?
We're running Ericsson IP-phones here, and nobody would be happier than me if it was impossible to tap them. However, I am most sure it's just me who is screwing up. Since I'm in charge of the IP phones here, it would be kinda nice to know.
So, any tips?
The calls appear in the VOIP section of the sniffer, but once the call is
completed, all I get is "Codec not supported" and the wav file is not saved. However, if I make a call and there is nobody answering, and then put the phone off hook, it has indeed recorded and saved a single "beep" (someone like 2 seconds), and the status field is left blank instead of displaying
"Codec not supported".
The codec reported is G72*, 8khz, Mono and according to the Cain&Abel manual this codec should actually be supported. So, why doesn't it work?
We're running Ericsson IP-phones here, and nobody would be happier than me if it was impossible to tap them. However, I am most sure it's just me who is screwing up. Since I'm in charge of the IP phones here, it would be kinda nice to know.
So, any tips?